앱 다운로드Get the app
홈Home/보일러·온수기Boilers & Water Heaters/Sime/보일러·온수기Boilers & Water Heaters
SI

Sime 보일러·온수기 에러코드 25개Sime Boilers & Water Heaters error codes (25)

Sime 보일러·온수기 화면에 뜨는 코드 25개의 뜻·긴급도·자가조치를 한 페이지에 모았습니다.All 25 Sime boilers & water heaters error codes — what each one means, how urgent it is and what you can do — on one page.

0즉시 정지Stop now
0AS 필요Service needed
0계속 사용 가능Keep using
25확인 필요Check needed

공통 조치 — 여러 코드에 같은 조치가 적용됩니다Shared steps — several codes share the same fix

① 코드 19개19 codes

전원을 껐다가 다시 켜 보세요. 증상이 계속되면 공식 서비스센터에 문의하세요.Turn the appliance off and on again. If the problem continues, contact an authorized service center.

Sime 보일러·온수기 에러코드 전체 (25)All Sime boilers & water heaters codes (25)

난방 배관 수압 낮음Low water pressure in system

보충 밸브로 난방수를 보충해 압력을 정상으로 맞추세요. 배관에 누수가 있는지도 확인하세요.Top up the heating system to restore pressure. Also check the system for leaks.

확인 필요Check needed

온수 센서 이상Domestic hot water sensor fault (return sensor fault for T models)

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

공급(mandata) 센서 이상Delivery sensor fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

화염 미감지(점화 실패)No flame detection

가스가 정상적으로 공급되는지 확인한 뒤 리셋하세요. 그래도 코드가 남으면 공식 서비스센터에 점검을 요청하세요.Check that the gas supply is on, then reset the boiler. If the code remains, contact an authorized service center.

확인 필요Check needed

안전 센서/서모스탯 작동Sensor or safety thermostat intervenes

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

화염 감지회로 이상Fault in the flame detection circuit

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

배관 물 순환 없음No water circulating in the system

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

센서 이상(수리적 설정 관련, Vera)Auxiliary sensor fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

가스밸브 변조기 분리됨Gas valve modulator disconnected

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

밀폐/개방형 챔버 설정 오류Domestic hot water sensor fault in tank mode

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

센서 이상(Vera)Smoke probe fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

팬 제어 케이블 분리됨Fan check cable disconnected

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

난방 NTC 2센서 간 편차가 최대 허용치를 초과(더블 센서 이상)Maximum deviation exceeded between the two heating NTC probes (double probe fault)

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

응축수 레벨 이상(사이펀, Vera)Condensate level fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

연속 잠금해제 최대 횟수 초과Maximum number of consecutive resets reached

전원을 껐다가 다시 켜 보세요. 그래도 코드가 남으면 공식 서비스센터에 점검을 요청하세요.Turn the power off and back on. If the code remains, contact an authorized service center.

확인 필요Check needed

환수 센서 이상("T" 버전, Vera)Return sensor fault (boiler sensor fault for T models)

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

전원 전압 낮음Fault due to low network voltage

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

전원 주파수 오류 감지Incorrect network frequency detected

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

화염 소실 6회 연속Flame loss more than 6 consecutive times

가스밸브가 열려 가스가 공급되는지 확인하세요. 그래도 코드가 남으면 공식 서비스센터에 점검을 요청하세요.Check that the gas supply valve is open. If the code remains, contact an authorized service center.

확인 필요Check needed

버튼 이상Button fault

제어판 버튼이 정상적으로 눌리는지 확인하세요.Check that the control panel buttons work properly.

확인 필요Check needed

이상(Vera, 연결 확인)Open Therm communication fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

공급센서 2번째 소자 이상Second delivery sensor fault

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

시동 시 연소 문제 잠금Block due combustion during start-up

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

불규칙 연소(일시 오류)Irregular combustion (temporary error)

조치: 공통 조치 ①Fix: shared steps ①

확인 필요Check needed

배기 막힘 잠금Block due to clogging in smoke outlet

배기 연통이 막혀 있지 않은지 확인하세요. 그래도 코드가 남으면 공식 서비스센터에 점검을 요청하세요.Check the chimney and flue for blockages. If the code stays, contact an authorized service center.

확인 필요Check needed

제조사 공식 출처Official manufacturer sources

다른 브랜드 보일러·온수기Boilers & Water Heaters from other brands

⚠ 정보는 참고용입니다. 감전·가스·누수처럼 위험이 의심되면 즉시 사용을 멈추고 제조사 서비스센터에 문의하세요.⚠ For reference only. If you suspect a hazard such as shock, gas or a leak, stop using the appliance and contact the manufacturer's service center.