앱 다운로드Get the app
홈Home/보일러·온수기Boilers & Water Heaters/Junkers/보일러·온수기Boilers & Water Heaters
Junkers

Junkers 보일러·온수기 에러코드 29개Junkers Boilers & Water Heaters error codes (29)

Junkers 보일러·온수기 화면에 뜨는 코드 29개의 뜻·긴급도·자가조치를 한 페이지에 모았습니다.All 29 Junkers boilers & water heaters error codes — what each one means, how urgent it is and what you can do — on one page.

4즉시 정지Stop now
25AS 필요Service needed
0계속 사용 가능Keep using

먼저 확인: 즉시 사용을 멈춰야 하는 코드 4개Check first: 4 codes that mean stop now

  • A2 연소실에서 배기가스가 새어 나오는 것이 감지되었습니다.Flue gas escaping at the combustion chamber.
  • A4 역풍방지기(연도 안전장치)에서 배기가스가 새어 나오는 것이 감지되었습니다.Flue gas escaping at the draught diverter.
  • F7 기기가 꺼져 있는데도 불꽃이 감지됩니다(잘못된 이온화 신호).Flame detected although the appliance is switched off (false ionisation signal).
  • FA 가스 차단 후에도 불꽃이 계속 감지됩니다(이온화 전류 잔류).Flame still detected after the gas supply has been shut off.

공통 조치 — 여러 코드에 같은 조치가 적용됩니다Shared steps — several codes share the same fix

① 코드 25개25 codes

전원을 껐다가 다시 켜 보세요. 코드가 다시 뜨면 공식 서비스센터에 점검을 요청하세요.Turn the appliance off and on again. If the code comes back, ask an authorized service center to inspect it.

② 코드 3개3 codes

가스 밸브를 잠그고 창문을 열어 환기하세요. 전기 스위치를 켜거나 끄지 마시고 불도 사용하지 마세요. 실외로 나온 뒤 가스공급업체나 공식 서비스센터에 연락하세요.Shut the gas valve and open the windows to ventilate. Do not switch anything electrical on or off, and keep all flames away. Go outside first, then call your gas supplier or an authorized service center.

Junkers 보일러·온수기 에러코드 전체 (29)All Junkers boilers & water heaters codes (29)

난방수 압력 부족으로 순환펌프가 공회전(건식 운전)했습니다. 시스템 충전압이 1.2bar 미만인지 확인 대상입니다.Modulating pump has run dry (system fill pressure too low).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

연소실에서 배기가스가 새어 나오는 것이 감지되었습니다.Flue gas escaping at the combustion chamber.

조치: 공통 조치 ②Fix: shared steps ②

즉시 정지Stop now

역풍방지기(연도 안전장치) 쪽 배기 온도센서(NTC)가 단선되었습니다.Flue gas NTC at the draught diverter is open-circuit.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

역풍방지기(연도 안전장치)에서 배기가스가 새어 나오는 것이 감지되었습니다.Flue gas escaping at the draught diverter.

조치: 공통 조치 ②Fix: shared steps ②

즉시 정지Stop now

온수 저장탱크 온도센서 2(Speicher-NTC 2)가 고장입니다.Cylinder NTC 2 defective.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

연소실 배기 온도센서(NTC)가 단선되었습니다.Flue gas NTC at the combustion chamber is open-circuit.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

온수 온도센서(NTC)가 고장입니다(단선 또는 단락).Domestic hot water NTC defective (open circuit or short).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

보일러와 실내조절기(컨트롤러) 사이 CAN 통신이 끊겼습니다.CAN communication between the boiler bus module and the controller interrupted.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

확장 모듈이 인식되지 않습니다.Module not detected.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

기기 사양을 지정하는 코딩 플러그가 인식되지 않습니다.Coding plug not detected.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

송풍기(팬) 회전수가 너무 낮습니다.Fan speed too low.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

고속 운전 중 배기 압력스위치 접점이 열렸습니다.Air pressure switch contact opens during operation at high fan speed.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

배기 압력스위치 접점이 열리지 않습니다.Air pressure switch contact does not open.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

배기 압력스위치 접점이 열린 상태로 유지됩니다.Air pressure switch contact remains open.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

외기 온도센서가 인식되지 않습니다.Outdoor temperature NTC not detected.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

LSM(안전 모듈)이 잠김 상태입니다. 온도감시기 등 외부 안전장치가 작동했습니다.LSM locked out (external safety device such as temperature limiter tripped).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

단자 8-9 사이의 점퍼(브리지)가 인식되지 않습니다(단자 개방).Bridge/jumper across terminals 8-9 not detected (terminal open).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

제어기판 내부 오류입니다.Internal fault on the PCB.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

난방 출수(공급) 온도센서(NTC)가 고장입니다(단선 또는 단락).Flow temperature NTC defective (open circuit or short).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

버너 출수 온도센서에서 과열 감지되어 안전 차단되었습니다.Safety cut-out triggered by the burner flow NTC (overheat).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

버너 쪽 출수 온도센서(NTC)가 단선 또는 단락되었습니다.Flow NTC at the burner is open-circuit or short-circuited.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

최저 수압 감시 스위치가 작동했습니다(난방수 압력 부족).Minimum pressure switch has tripped.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

안전 온도 제한기(STB)가 작동해 기기가 잠겼습니다(과열).Safety temperature limiter (STB) has tripped.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

운전 중 불꽃이 감지되지 않습니다(이온화 전류 없음). 가스 공급·응축수 배출·배기 막힘이 원인일 수 있습니다.Flame not detected during operation (no ionisation current).

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

제어부 내부 오류입니다.Internal fault.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

기기가 꺼져 있는데도 불꽃이 감지됩니다(잘못된 이온화 신호).Flame detected although the appliance is switched off (false ionisation signal).

지금 바로 사용을 멈추고 전원을 차단하세요. 직접 분해하거나 수리하지 마시고, 공식 서비스센터에 점검을 요청하세요.Stop using the appliance now and cut the power. Do not open it up or repair it yourself — ask an authorized service center to inspect it.

즉시 정지Stop now

가스 차단 후에도 불꽃이 계속 감지됩니다(이온화 전류 잔류).Flame still detected after the gas supply has been shut off.

조치: 공통 조치 ②Fix: shared steps ②

즉시 정지Stop now

텍스트 디스플레이가 인식되지 않습니다.Text display not detected.

조치: 공통 조치 ①Fix: shared steps ①

AS 필요Service needed

제조사 공식 출처Official manufacturer sources

다른 브랜드 보일러·온수기Boilers & Water Heaters from other brands

⚠ 정보는 참고용입니다. 감전·가스·누수처럼 위험이 의심되면 즉시 사용을 멈추고 제조사 서비스센터에 문의하세요.⚠ For reference only. If you suspect a hazard such as shock, gas or a leak, stop using the appliance and contact the manufacturer's service center.